Prusa i3 MK3 printer

I recently purchased an i3 mk3.
These are running notes related to setup/initial observations etc.

I. Protopasta HTPLA filaments jam.

https://www.proto-pasta.com/blogs/how-to/avoid-jams-to-print-reliably-with-htpla-on-the-prusa-mk3-e3d-hotends

https://www.proto-pasta.com/blogs/how-to/tuning-for-carbon-fiber-htpla-on-your-prusa-mk3-or-other-3d-printer

II. Octoprint

The Einsy board has a “RPi Port” designed to allow the i3 mk3 to communicate with a Raspberry Pi Zero W via SPI and Serial.

Prusa semi-officially supports octoprint/prusa print on a Pi Zero W.

You can of course use any Pi that can run octoprint. You can even use the hardware pins. But, note, that all Pis do hardware serial a bit differently. Specifically, the UART pins can be shared with bluetooth on some boards etc.
Look up how to “enable hardware serial for **insert your pi model here**”

However, I decided to use a USB connection with stock Octoprint on a RPi 4, and I am very happy. I don’t see the need to hardwire the pins. Frankly, the performance of hardware UART across the different Pi models is all over the place.

There is a bit of FUD around on RPi4s and Octoprint — I haven’t encountered issues.

The interactions between octoprint via USB and the i3 Einsy board are fine. It just offers an alternative way to use the printer. I still feel like I have my stock printer.

Julia Ebert has some excellent notes on setting any Pi/Octoprint with the i3:
https://docs.juliaebert.com/3d-printing/octoprint